Description
You can cut a single INNI to the desired length (between 73 3/4″ – 22″) on-site prior to installation. This gives you a precise, wall-to-wall drain channel that enables a single slope floor – ideal for large format tile.
Three ways to Install:
- In-Sight Install: This installation places the Drain Channel away from the walls in your shower.
- At-Wall Install: This installation places the Drain Channel flush against a tiled wall.
- In-Shadow Install: This installation places the Drain Channel under the wall tile. This is the least visible option.
NOTE: The INNI Drain Body is made of ABS, glues directly to a 2″ waste pipe. PVC requires adaption via crossover cement or rubber coupling.
If you are doing a hot-mop installation, an INNI Hot Mop Receptor is required. (Sold Separately)
The INNI’s internal slope maintains water flow for a fresh, clean drain. Custom Brush Sets (sold separately) are easily able to clean all internal surfaces. Its access panel is smaller than your phone, for easy cleaning and waste pipe access.
Once you try the INNI, you’ll never go back!
Ebbe INNI connects directly to 2″ ABS pipe.
As a quick reference, here are the tools NOT included in the kit needed for installation:
- At least 4 oz. ABS cement
- Power Drill
- Circular Saw, Miter Saw, Tile Saw
- Urethane Sealant and Caulk Gun
- Fiberglass Mesh Tape
- Tape Measure
- Utility Knife
- Polymer Modified Thinset
- Square
- Spirit Level
- Min. 3/8 x 3/8 Notched Trowel
Ebbe INNI Cleaning Brush Set (E6103)The INNI Cleaning Brush Set is custom cut to the size of your installed INNI and is used to clean all internal surfaces of the drain body and slot with ease.
Cleaning Brush Sets have been specifically designed to make maintenance of your INNI Line Drain effortless.
Through the access opening, a flexible stainless steel shaft with a D-shaped brush head cleans all interior surfaces with a simple push-pull motion.
Made of durable non-corrosive materials these cleaning brushes will give years of carefree service.
Ebbe INNI Hair Trap (6-pack) (EILD-HT)A single INNI Hair Trap comes with this INNI Line Drain Kit and replacement Hair Traps are sold in packs of 6.
They are used to keep hair and debris out of your waste pipe for easy cleaning and maintenance.
INNI Coupler Kit (E6106)The INNI Drain Coupler Kit joins two INNI Line Drains together to create a drain channel longer than 73 3/4″.
Each INNI installed requires it’s own waste pipe connection.
The INNI Tile-In Access Cover comes with this INNI Line Drain Kit and replacements can be purchased separately.
The Tile-In Access Cover matches the thickness of your tile and is used to cover/access the waste pipe below the INNI drain body.
The INNI In-Shadow Trim comes with this INNI Line Drain Kit and replacement Trims are sold as a single 36″ piece.
This trim enables the In-Shadow installation of the INNI Line Drain, where the drain channel rests underneath the shadow of your wall tile.
The INNI In-Sight Trim comes with this INNI Line Drain Kit and replacement Trims are sold as a single 36″ piece.
This trim creates a clean edge and finish within the drain channel.